General information, Safety information – Hach-Lange POLYMETRON 9240 Basic User Manual User Manual
Page 4

Specification
Details
Measurement category
Cat II, Class 1 (overvoltage < 1500V)
Maximum panel dimension (H x L x
D)
850 x 450 x 252.5mm [33.46 x 17.71 x 9.94in]
Inlet
Simple fittings for 6 mm O.D. tubing or ¼" O.D. in PE-low density. ¼" OD
in PHED-PTFE-SS as option
Outlet
Barbed stem for 12 mm (½" I.D.) hose
Protection rate
Transmitter: IP65 (NEMA 4)
Panel: IP50 (dust protection)
Optional Enclosure: IP54 (splash water proof)
Instrument is designed to avoid DIPA vapor inside the enclosure. All DIPA
vapor is collected and sent to the instrument drain
Cell
PMMA - compact (minimum tubing)
Flame rate
Conform UL
Maximum weight
15 - 30 Kg
Mains power supply
100 - 240 VAC, 50-60 Hz, ± 10%, automatic switching
Max. consumption
80 VA
Fuse
5 x 20 cartridge T2AL-250V following CEI127
Display
Curve trend, Last Cal Date, Historical, Concentration, Temperature,
Potential
Analog outputs
Number: 6
4-20 or 0-20 mA (650 ohms)
Linear / Dual / Logarithm
Event indication
Relays
4 x Relay (conc)
1 x Warning
1 x System
Logic input
Active / Inactive channels
Remote AutoCal
European standards
EN 61326 Class A for EMC; EN 601010-1 for low voltage safety
International standards
cETLus
General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer’s website.
Safety information
N O T I C E
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
4 English