Clear-Com BS850 (Last time buy) User Manual
Page 25

22
Beltpac Buttons C and D Setup:
Select the Beltpac and the Mode (Off or Momentary)
for Buttons C and D on each Beltpac.
ISO1 = Talk, to Beltpacs receiving only TX1
ISO2 = Talk, to Beltpacs receiving only TX2
ISO = Talk, to Beltpacs receiving both TX1 and TX2
Page = Talk, Page (stage announce)
Aux = Talk,
Auxiliary
Out
Chan = Toggle Ch1/Ch2
Call = Call
Signal
Alert = Alert Signal
NOTE: Call Signal only functions when the Talk
function is active, and only from a Beltpac to
other Beltpacs which have been preset to produce
a tone upon receipt of a call signal.
Beltpac LED Settings:
Select the Beltpac and select the desired functions
for the LEDs on each Beltpac.
Beltpac Tone Settings:
Select a Beltpac, then select the events for which
you would like tones to sound in that Beltpac
user’s headset.
Beltpac User Identifier Settings:
To assign identification to a Beltpac, such as a
user’s name, select a Beltpac then use the arrow
buttons and selector knob to assign a name and
number to each Beltpac.
NOTE: Each Beltpac must have a different
number, and each assigned number must be
programmed into the base, or the base will not
recognize the Beltpac.
Names can also be used if desired.