Clear-Com BS850 (Last time buy) - Manual (Page 2)

• Open the Beltpac case.
• Remove the two mounting screws from the power supply circuit board as shown
in Figure 3.
Figure 3. Remove mounting screws
• Lift the circuit board assembly out of the Beltpac and set it beside the case as
shown in Figure 4.
Figure 4. Set circuit board assembly next to case
• Install the receiver module on the main circuit board in the position shown in
Figure 5, pressing it firmly onto the two connector plugs.
Figure 5. Install receiver module
NOTE: The two connectors are
polarized, and will only allow the
module to be plugged in one way.
2