Clear-Com BS850 (Last time buy) - Manual

PRO850 Dual-Receiver Beltpac
HM ELECTRONICS, INC. 14110 Stowe Drive, Poway, CA 92064 USA
• Phone: 1-800-848-4468 Fax: (858) 552-0172
HME# 400G550
Rev A 2/28/05
Second Receiver Module
INSTALLATION INSTRUCTIONS
CAUTION : Both the second receiver module and the Beltpac contain static sensitive
d devices. Comply with ESD safe handling procedures while following these instructions.
A second receiver added to the PRO850 Dual-Receiver Beltpac allows simultaneous use of two
channels of intercom or one intercom channel plus an IFB. The following instructions will
guide you through installation of a second receiver module in a PRO850 Beltpac.
Figure 1. Second receiver module
PROCEDURE
Open the Beltpac and install the second receiver module as follows:
• Unscrew/Remove the two antennas and remove the battery pack from the Beltpac.
• Loosen/Remove the six screws from the Beltpac, shown in Figure 2.
Figure 2. Remove six screws from Beltpac
NOTE: If you loosen (but do not
remove) the connector screw shown
below, just enough to open the
Beltpac case, it will hold the metal
bracket inside the connector in place.
Loosen this
connector
screw
Remove this
connector
screw