Clear-Com ICS-22 - Manual (Page 19)

Vitec Group Communications
ICS-22 Speaker Panel Instruction Manual 3 - 1
INSTALLATION
1. Connect the 14- to 18-VAC power to the two-position terminal strip.
Plug the terminal strip onto the P2 as shown in Figure 1-2 on page
1-6.
2. Connect the eight-wire, modular RJ-45 connector to J1 as shown in
Figure 1-2 on page 1-6.
3. If the RJ-45 Matrix connector should need to be unplugged, use the
following procedure:
1. Remove power from the panel.
2. If the panel is installed in a DT-Box, remove the front panel. It is
retained with four screws.
3. Using long-nosed pliers, grasp the top and bottom of the plug so
that the retaining clip will be depressed. Pull the plug out with the
pliers.
Figure 3-1: ICS-22 DT-Box Wiring
• The ICS-22 runs on
14- to 18-VAC power.
• Note: If the panel is
installed in a DT-Box,
the back cover of the
DT-Box must first be
removed. It is
retained with four
screws. Feed the
power cable through
one slot and fasten it
to the strain relief as
shown in Figure 1-2.
• Removing the RJ-45
Matrix connector
requires three steps.
• Note: If the panel is
installed in a DT-Box,
the back cover of the
DT-Box must first be
removed. Feed the
Matrix cable through
one slot and fasten it
to the strain relief as
shown in Figure 3-1
at right.
3