beautypg.com

Installing the new front-panel assembly – Clear-Com ICS-2003 User Manual

Page 5

background image

U P G R A D I N G T H E F R O N T - P A N E L D I S P L A Y O N T H E I C S - 2 0 0 3

5

INSTALLING THE NEW FRONT-PANEL ASSEMBLY

Install the panel microphone bushing on the new front panel. Reinstall the black plastic microphone
connector in the microphone bushing. Use the 1/4-inch nut driver to install the two nuts that hold
the headset microphone connector in place.

1

STEP

panel microphone bushing

black plastic panel
microphone connector

1/4-inch nuts

1 of 4 #8 plastic hex nuts

1 of 4 #8 plastic screws

Install the speaker on new circuit board by securing the four #8 plastic screws
into the four #8 plastic hex nuts as shown. Use the 11/32-inch nut driver to tighten,
to avoid damaging the speaker.

2

STEP

speaker

speaker circuit board

See also other documents in the category Clear-Com Accessories communication: