Clear-Com ICS-2003 User Manual
Removing the old front-panel assembly
U P G R A D I N G T H E F R O N T - P A N E L D I S P L A Y O N T H E I C S - 2 0 0 3
1
The front-panel upgrade kit for the ICS-2003 matrix
station includes a new fluorescent display, new
front-panel circuit boards, and a new set of toggle keys.
When the kit is installed, you will have a new
state-of-the-art station for your Matrix Plus 3 system.
The upgraded vacuum fluorescent display (VFD)
dramatically extends the life span of the station and
improves its readability in all lighting conditions.
Clear-Com’s factory can install the kit for you for a fee,
or you can install the kit yourself. The following
instructions show you how to install the kit yourself if
you choose to do so.
NOTE: To order the kit, refer to “FPVD-2003” (front-panel
upgrade kit for the ICS-2003 matrix station.)
To install the new front panel you will need the following
tools:
• Phillips screwdriver
• 1/4-inch nut driver
• 5/16-inch nut driver
• 11/32-inch nut driver
• 5/8-inch nut driver
Please read and follow these instructions. Damage to
components may occur if these instructions are not followed.
2
Disconnect the intercom station from its power source. Set it on the table facing you.
1
Remove the six screws that fasten the cover to the station
and remove the cover.
STEP
STEP
REMOVING THE OLD FRONT-PANEL ASSEMBLY
UPGRADING THE FRONT-PANEL DISPLAY
ON THE ICS-2003 MATRIX STATIONS
4065 Hollis St.,
Emeryville,CA 94608
Phone: (510) 496-6666
Fax: (510) 496-6699
www.clearcom.com
P/N 810317 Rev. A