Cashco Premier - Manual (Page 2)

IOM-148 2
TABLE 1
ACTUATOR MODEL NO. vs. VALVE BODY MODEL
(Model 48 included for clarity)
III. INSTALLATION
A. Orientation:
1. Recommended actuator major axis ori en ta tion
with any model of Cashco rotary control valve
is upwards with the valve in a horizontal pipe
and the valve stem also horizontal; i.e. position
“A” for ATO-FC, or position “B” for ATC-FO.
2. Both Ranger QCT and Premier EZO/Unlined
control valve products incorporate an ex tend ed
SECTION III
FIGURE 2: Mounting position of Ranger QCT to Model
148 Actuator with Model 73N-B P/P Positioner. FIGURE 3: Mounting position of Ranger QCT to Model
148 Actuator with Models 9540R P/P or Smart Posi-
tioner’s PS2 and 991.
valve body bon net and a mounting yoke to
allow the actuator to be far enough away
from the valve body or mounting fl anges to
in cor po rate a minimum of 2" (50 mm) thick-
ness of in su la tion. It should not be necessary
to install thermal insulation to any portion of
Model 148 actuator. The maximum ambient
temperature for installation is 180°F (83°C);
the minimum ambient temperature is -20°F
(-29°C).
Position A
Position B
Position A
Position B
Full Actuator Model No.
Available
Bench Settings
Air Supply
Pressure
Unitized Products* Basic
Actuator
Model No.
Modifi er
Number
psig (Barg) psig (Barg)
48R
or
48D
-01 5-15 (.34-1.03) 20 (1.4)
1”-2” (DN25-50) Ranger QCT
3”-4” (DN80-100) Premier EZO or
Premier Unlined
148R
or
148D
-01 5-13 (.34-0.90) 20 (1.4)
3”-4” (DN80-100) Ranger QCT
6” (DN150) Premier EZO
or Premier Unlined
148R
or
148D
-02 10-26 (.69-1.79) 36 (2.5)
4”-8” (DN100-200) Ranger QCT,
10” (DN250) Premier EZO
148R
or
148D
-03
7.5-
19.5
(.52-1.34) 27 (1.9)
8” (DN200) Premier EZO,
8”-12” (DN200-300) Premier
Unlined
* Metric body size in parenthesis.