Hydrotech Reverse Osmosis Drinking Water System c_w Booster Pump and Inlet Solenoid - Manual (Page 13)

11
Connecting Components
a. Connect the 1/4” white tube to the elbow of
sump #1. The other end of the elbow should be
connected to inlet saddle valve. Refer to inlet
saddle valve installation on page 6.
b. Cut 3/8” blue tubing supplied to the desired length.
Connect the 3/8” blue tube from the (90° elbow)
granular activated carbon post-filter (Sump #3)
fitting to the quick connect fitting on the faucet
adapter. Refer to faucet installation on page 9.
c. Connect the 3/8” white tube to the center of
the male tee located on the top of the bracket.
Connect the other end of the tube to the storage
tank. Refer to the storage tank connection
installation on page 7.
d. Connect the 1/4” red tube to the flow restrictor
and attach the other end to the drain saddle
valve. Refer to the drain saddle valve installation
on page 7.
Flow Restrictor
3/8”
White
Tubing
to Tank
1/4” White
Inlet Tubing
from Inlet
Saddle Valve
3/8”
Blue
Tubing
to
Faucet
Sump #3
Post-
Carbon
Filter
Sump #1
Pre-Sediment
Filter
Sump #3
Post-
Carbon
Filter
1/4” Red
Tubing to
Drain Saddle
Valve
RO Membrane
Housing