Actron CP9125 - Manual (Page 11)

5.Press and Hold ERASE ERASE ERASE ERASE ERASE Key for
3 Seconds and Release.
6.Observe “ERASE? ERASE? ERASE? ERASE? ERASE?” Displays.
7.Press and Hold ERASE ERASE ERASE ERASE ERASE Key
for 3 Seconds and Release.
8.Observe a Moving - on Display.
NOTE: If a “NO LINK” message
displays, cycle ignition key to
the OFF position for 10
seconds, then back ON, and
repeat “Erasing Diagnostic Data.”
9.Observe “DONE DONE DONE DONE DONE” Displays.
NOTE: If the problem causing Diagnostic Trouble Code(s) still
exists, the code will return. The Diagnostic Trouble
Code may return immediately or may return after vehicle
has been driven.
NOTE: Pressing READ READ READ READ READ /Scr /Scr /Scr /Scr /Scroll Do oll Do oll Do oll Do oll Down wn wn wn wn key will read
Diagnostic Trouble Codes and Data and Holding
ERASE ERASE ERASE ERASE ERASE key will erase results again.
11
ERASE?
-
DONE
NO LINK