Burkert Type S030 User Manual
Page 3
8
note
the fitting may be damaged by the fluid in contact
with.
• Systematically check the chemical compatibility of the
component materials of the fitting and the fluids likely
to come into contact with it (for example: alcohols,
strong or concentrated acids, aldehydes, alkaline
compounds, esters, aliphatic compounds, ketones,
halogenated aromatics or hydrocarbons, oxidants and
chlorinated agents).
English
9
4. GenerAl informATion
To contact the manufacturer of the fitting use following
address:
Bürkert SAS
Rue du Giessen
BP 21
F-67220 TRIEMBACH-AU-VAL
The addresses of our international branches can be found
on the Internet at:
www.burkert.com
Warranty conditions
The condition governing the legal warranty is the conforming
use of the S030 in observance of the operating conditions
specified in this manual.
information on the internet
You can find the user manuals and technical data sheets
regarding the type S030 at:
www.burkert.com
English
9
10
5. deScripTion
Area of application
The S030 HT fitting is intended to measure the flow rate of
clean fluids in DN6 to DN50 pipes thanks to its paddle-wheel.
Its combination with an SE30 HT electronic module builds a
flowmeter 8030 HT.
The electronic device can be removed without opening the
piping or stopping the process.
measuring principle
The fluid flowing in the piping makes the paddle-wheel turn.
The paddle-wheel rotational frequency f is proportional to
the flow rate.
English
11
6. TecHnicAl dATA
conditions of use
Ambient temperature
(operating)
-15 to +80 °C, if the fitting is com-
bined with an SE30 HT electronic
module
Pressure class
• PN40 if -15 °C < T fluid < 90 °C
• PN25 if
90 °C < T fluid
≤
125 °C
Fluid temperature
-15 to +125 °C
conformity to the pressure
directive
The S030HT fitting complies with article 3 of §3 from
97/23/CE directive.
Acc. to the 97/23/CE pressure directive, the fitting can
only be used in the following cases (depending on max.
pressure, pipe diameter and fluid):
type of fluid
conditions
Fluid group 1 § 1.3.a only DN ≤ 25
Fluid group 2 § 1.3.a DN ≤ 32
or DN > 32 and PNxDN ≤ 1000
Fluid group 1 § 1.3.b PNxDN ≤ 2000
English
11