General information, Manufacturer's address and international contacts, Warranty conditions – Burkert Type 8012 User Manual
Page 8: Information on the internet, Description, Area of application, General description, Construction
8
Generalinformation
Type 8012
4.
GeneRAl infoRmATion
4.1.
manufacturer's address and
international contacts
To contact the manufacturer of the device use following address:
Bürkert SAS
Rue du Giessen
BP 21
F-67220 TRIEMBACH-AU-VAL
You may also contact your local Bürkert sales office.
The addresses of our international sales offices can be found on the
last pages of this manual. They are also available on the Internet at:
4.2.
Warranty conditions
The condition governing the legal warranty is the conforming use of
the 8012 in observance of the operating conditions specified in this
manual.
4.3.
information on the internet
You can find the user manuals and technical data sheets regarding
the type 8012 at:
5.
DescRipTion
5.1.
Area of application
The 8012 flowmeter with magnetic sensor is intended to measure the
flow rate of neutral or slightly aggressive liquids free of solid particles.
The 8012 flowmeter with optical sensor is intended exclusively for
measuring the flow rate of liquids that allow the passage of infrared rays.
5.2.
General description
5.2.1. construction
The 8012 flowmeter comprises the SE12 electronics incorporating
the measuring paddle-wheel and an S012 fitting allowing the device
to be fitted to all types of pipes from DN6 to DN65.
The sensor detects the rotation of the paddle-wheel; it generates a
signal in which the frequency f is proportional to the rotation frequency
of the paddle-wheel.
The electronic module is fitted with 2 LEDs visible by transparency on
the side of the housing:
• A green LED is on when the device is energized (the paddle-
wheel is not running) and then flashes proportionally to the
rotation frequency of the paddle-wheel.
• A red LED signals a malfunction of the flowmeter (see chap.
10.4.1).
English