Burkert Type 8642 - Manual (Page 3)

INSTALLATION AND COMMISSIONING
Terminal connections
INSTALLATION AND COMMISSIONING
Setting the station addresses
INSTALLATION AND COMMISSIONING
Terminal connections
Bürkert piezo-valves type 6520 may be connected to the terminals
for actuators. Observe polarity. More detailed instructions for
connection and operation of the valves are to be found in the PTB
Test Certificate and in the Operating Manual for the valves. DIP switch 1 to 7: Bit 1 to Bit 7
The LED flashes when the device is engaged in cyclic data
communication. The LED lights briefly on connecting the device. If
the device detectes an internal error, the LED remains lit.
ot
nity EMC
fil the
rminal
able that
to
ffecting
cuit
Connection of the sensors to
the terminals: Connection of the actuators
to the terminals:
Two sensors are always allocated to a valve. The sensors report the
end position of a connected process valve. The inputs can also
report other process parameters independent of the valves (e.g.
scraper end positions).
The DIP switches are only read in when the unit is switched
on.
In the PROFIBUS PA, each station is given an adress. These
addresses are set up using the DIP switches 1 to 7. The
permissible address range lies between 3 and 124.
Settings:
If switch 8 is in the ON position, the internal address is used!
This adress can be set up via the field bus.
LED display
Polarity - +
Terminals 152 151
Terminals 142 141
Terminals 252 251
Terminals 242 241
Terminals 352 351
Terminals 342 341
Terminals 452 451
Terminals 442 441
Polarity + -
Terminals 148 147
Terminals 248 247
Terminals 348 347
Terminals 448 447
2 0 2 1 2 2 2 3 2 4 2 5 2 6
DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6 DIP-7 Address
ON ON OFF OFF OFF OFF OFF 3
:
OFF OFF ON ON ON ON ON 124
ON OFF ON ON ON ON ON 125
OFF ON ON ON ON ON ON 126*
*Delivery state: Address 126
Terminals A (exit) and
E (entry):
Connection for the
PROFIBUS-PA field
bus: any polarity can
be used between
terminal 1 and 2.
Max. permissible
torque for the bus
connections
(Weidmüller): 5 Nm.