Alamo RX72 EN - Manual (Page 85)

ASSEMBLY
RX60/72/84 03/09 Assembly Section 3-3
© 2009 Alamo Group Inc.
ASSEMBL
Y
TAIL WHEEL INSTALLATION
(Model RX60 & RX72)
Align Tail Wheel Beam Weldment (1) between pivot
brackets located behind gearbox mount on the
Mainframe Weldment. NOTE: Long side of caster
fork pivot tube is positioned up. Attach the Tail
Wheel Beam Weldment (1) to the Mainframe
Weldment with one 5/8” Bolt (4), and 5/8” nut (5).
Slide Tail Wheel Beam Weldment (1) into Gauge
Wheel Mount Weldment (3) and retain with two 1/2”
x 1-1/2” bolts (6), and locknuts (7).
1. Insert the Caster Fork Weldment (11) into the
Tail Wheel Beam (1) and retain with Flatwasher
(9) and Cotter Pin (10).
2. Tighten all bolts to the proper torque. Figure
Asm-R-0408.
TAIL WHEEL INSTALLATION - LIFT TYPE (Model RX84 Only)
1. Slide bracket (2) onto beam (1).
2. Insert bolt (28) through lugs on end of beam (1)
and lug on deck.
NOTE: Insert spacer (10)into deck lug before
inserting bolt (28). Install locknut (3).
3. Install bracket (4) to rear center of deck using
bolt (24) and retain using locknut (23).
4. Insert bolt (24) through holes in brackets (2)
and (4) which will give approximately desired
cutting height. Install locknut (23) and tighten all
bolts. Figure Asm-R-0402.