BJM Pumps SKX SERIES SHREDDER PUMPS - Manual (Page 9)

9
2. By looking from the top of the pump. Since the impeller cannot be seen, the best
way to check the rotation is to check the kick back motion of the pump when the
pump just starts. The kick back motion of the pump should be counter clockwise
as shown in the picture below.
PUMP OPERATION
This pump is designed to handle dirty water that contains some
solids. It is not designed to pump volatile or flammable liquids. Do not attempt to pump
any liquids which may damage the pump or endanger personnel as a result of pump
failure.
Do not operate this pump where explosive vapors or
flammable material exist. Death or Serious injury will result.
TYPICAL MUNICIPAL AND INDUSTRIAL WASTEWATER INTALLATION
NOTE: Maximum recommended starts should not exceed 10 times per hour.