BJM Pumps SKX SERIES SHREDDER PUMPS - Manual (Page 10)

10
MANUAL OPERATION
All SK & SKX Models are provided with a 33’ (10 m) power cord. NEVER splice the
power cable due to safety and warranty considerations. Always keep the plug end dry.
Note: 230V, single phase and 208V, 230V, 460V & 575V three phase units do not
have a plug and have to be provided separately.
Do not alter the length or repair any power cable with a splice. The
pump motor and cable must be completely waterproof. Damage to the pump or
personal injury may result from alterations.
For manual operation: 115 volt: plug the power cable into any 115 volt grounded
receptacle. 208, 230, 460 & 575 volt: Attach the proper plug, connect directly to the
power source or control box. Check the direction of the rotation. Tilt the pump and start
it. It should twist in the opposite direction of the arrow (on pump). It is recommended
that a Ground Fault Interrupter (GFI) type receptacle (or equivalent) be used.
Single phase pumps always use a three-prong grounded
receptacle. It is recommended that a Ground Fault Interrupter (GFI) type receptacle (or
equivalent) be used.