Start-up report form – BJM Pumps SX75CSS-575T User Manual
Page 33

START-UP REPORT FORM
START-UP REPORT FORM
This form is designed to record the initial installation, and to serve as a guide for troubleshooting at a
later date (if needed).
BJM Pumps, LLC
123 Spencer Plain Road
Old Saybrook, CT. 06475
Pump Owner’s Name
Location of Installation
Date of Installation:
Dealer
Dealer Phone ( )
Date of Purchase
Model
Serial No
Voltage
Phase
Hertz
HP
Does impeller turn freely by hand?
Yes
No
Condition of Equipment
New
Good
Fair
Poor
Condition of Cable Jacket
New
Good
Fair
Poor
Rotation: Direction of Impeller Rotation (viewed from bottom)
(Use C/W for clockwise, CC/W for counterclockwise):
Resistance of cable and Pump Motor (measured at pump control)
Red-Black
ohms
Red-White
ohms
White-Black
ohms
Resistance of ground circuit between control panel and outside of pumps
Ohms
MEG
OHM CHECK OF INSULATION
Red to ground
White to ground
Black to ground
Condition of location at start-up
Dry
Wet
Muddy
Was equipment stored
If YES, length of storage:
Yes
No.
Liquid being pump
Debris in bottom of station?
Yes
No
- SX75CSS-460T SX75CSS-230T SX55CSS-575T SX55CSS-460T SX55CSS-230T SX55CSS-208T SX37CSS-575T SX37CSS-460T SX37CSS-230T SX37CSS-208T SX22CSS-575T SX22CSS-460T SX22CSS-230T SX22CSS-208T SX15CSS-575T SX15CSS-460T SX15CSS-230T SX15CSS-208T SX1500CSS-230 SX750CSS-230 SX750CSS-115 SX08CSS-575T SX08CSS-460T SX08CSS-230T SX08CSS-208T S75C-575T S75C-460T S75C-230T S55C-575T S55C-460T S55C-230T S55C-208T