EXP Computer CRW with DVD ROM Card - Manual (Page 32)

- 26 -
SOFTWARE INSTALLATION FOR OS/2 WARP
Before installing the external CD-RW device driver for OS/2 WARP, make sure your computer is
PCMCIA supported. If you are not sure about this, please refer to the last part of this chapter for
‘Adding PCMCIA Support’.
Automatic Installation
1. Insert the device driver diskette into floppy drive on your computer.
2. Open ‘OS/2 WARP’, and then open ‘Drives’.
3. Select Drive A or B depending on which floppy drive contains the device driver diskette.
4. Open ‘OS2WARP’ folder. Then double-click on ‘INSTALL2.EXE’.
5. A dialog box will be displayed for you to
specify the OS/2 directory, the I/O address
for the PCMCIA CD-RW and the IRQ
number. After specifying the OS/2
directory, press TAB to set the I/O port and
then the IRQ. The default setting of the I/O
ports is 320-32F, and the default IRQ is
11. After completing the selection, press
TAB to the Install button and press ENTER to continue.
6. The rest of the installation will proceed automatically. At the end, the on-screen instruction will
prompt you to restart your computer to activate the external drive for OS/2 Warp.