EXP Computer CRW with DVD ROM Card - Manual (Page 17)

- 11 -
SOFTWARE INSTALLATION FOR WINDOWS Me
1. Boot-up your computer into Windows Me, making
sure the device driver for ‘PCMCIA Socket’ has been
installed and is available. To check this, right-click
‘My Computer’, click ‘Properties’ and then ‘Device
Manager’ to open the ‘Device Manager’ window.
Refer to the figure shown alongside to see if the
PCMCIA Controller is installed without error.
2. Ensure the PCMCIA interface cable and then the AC adapter connections are made as described in
Hardware Installation. Slowly insert the PC Card of interface cable into the PCMCIA socket of
computer and press firmly until the connector is seated (Please note that the PC Card is keyed to
guide for proper insertion).
3. On the first screen, insert the device driver
diskette into floppy drive, select ‘Automatic
search for a better driver (Recommended)’, and
then click Next.
4. Windows will find two driver files from
the floppy diskette and list as the figure
shown alongside. In fact, these two
drivers are the same, choose any one
and then click OK.