EXP Computer CRW with DVD ROM Card - Manual (Page 14)

- 8 -
SOFTWARE INSTALLATION FOR WINDOWS 98/95B
Note:
♦ This external CD-RW won’t work under earlier version of
Windows 95, please check the version of your Windows 95
(you may right-click ‘My Computer’, and then click
‘Properties’, the version will be shown as the figure), make
sure the version is 4.00.950B. If your Windows 95 is version
4.00.950 or 4.00.950A, it is probably causes problem.
♦ The following installation procedures are extracted from the
Windows 98SE installation. The installation for Windows
95B (OSR2) and Windows 98 are almost the same.
1. Boot-up your computer into Windows 98, making
sure the device driver for ‘PCMCIA Socket’ has been
installed and is available. To check this, right-click
‘My Computer’, click ‘Properties’ and then ‘Device
Manager’ to open the ‘Device Manager’ window.
Refer to the figure shown alongside to see if the
PCMCIA Controller is installed without error.
2. Ensure the PCMCIA interface cable and then the AC adapter connections are made as described in
Hardware Installation. Slowly insert the PC Card of interface cable into the PCMCIA socket of
computer and press firmly until the connector is seated (Please note that the PC Card is keyed to
guide for proper insertion).