eLine Technology PRO3 Effio E - Manual (Page 5)

7 8
NOTE: Make sure you don’t have any missing parts before you make the installation.
Incorrect installation could void the warranty if instructions are not followed correctly.
Please call technical for assistance if you are unsure about any procedures.
Identification
Mechanical Drawing
Installation
Installation information
(General overview)
1 Remove the dome and camera cover using the supplied L-Wrench (D)
2 Using the base as a drilled template. pre-drill all requires holes.
3 Fit the Waterproof Pad (F) to the base, with sticky side against camera.
4 Now refit back camera, be careful of cable so not to cut or snag.
5 Adjust position and Focus & zoom, replace cover using L-Wrench
6 Carefully clean the dome surface with a soft lint free cloth.
7 Check IR LEDs are working by covering the photocell of camera with
your thumb, the IR LEDs will give a faint red glow.
(Don’t look at IR LEDs for long periods of time, as you could damage your eyes)
Accessories
1
4 3
2
5 6
Pan360
Tilt 90
Rotate 180 Camera body
View angle adjustment lever
Focus adjustment lever
(D) L-Wrench
T15 Size
(E) Drill Template
130mm White adhesive (B) Fitting Screws
PA4 x 30mm (A) Wall Plugs
5.6 x 29mm
(C) Opening Tool
50 x 1.8mm (F) Waterproof Pad
128 x 2.5mm black EVA
127 mm
5 in
150 mm
6 in
3/4” 14
NTS thread
3/4” - 14
NTS thread
46.0 mm
2 in
83.5 mm
3 1/2 in
Close / Open