eLine Technology PRO3 Effio E - Manual (Page 11)

19 20
NOTE: Make sure you don’t have any missing parts before you make the installation.
Incorrect installation could void the warranty if instructions are not followed correctly.
Please call technical for assistance if you are unsure about any procedures.
Identification
Mechanical Drawing
Installation
Installation information
(General overview)
1 Remove dome dome and use as drill template. Attach using plugs (A) and screws (B)
2 Once base is firmly drilled into place, re-assemble parts.
3 Attach power and video. Connector types can be either A or B types.
4 Position camera to suite make tight using the ring, only requires hand.
5 Adjust the zoom & focus using the tool (C) provided (Vari-Focal models)
6 Adjust camera settings via the hidden OSD access point. Remove screws to access.
7 Check IR LEDs working by just covering the photocel of camera
with your thumb, the IR LEDs will give a faint red glow.
(Don’t look at IR LEDs for long periods of time, as you could damage your eyes)
Accessories
(B) Fitting Screws
PA4 x 35mm 4pc (A) Wall Plugs
S8 x 30mm 4pc (C) Adjustment Tool
Vari-Focal Model
OSD Adjust
1
4 3
2
5 6
70
70
120
Focus adjustment
Zoom adjustment
Adjust wrench
Pan 360°
Three axis rotate
70 mm
3"
70 mm
3"
Ø 120 mm
4 1/2"
120 mm
4 1/2"
105.5 mm
4"
전원 커넥터
비디오 커넥터
Power connector
Type B
Type A
Video connector