Reading out measured values, 2 reading out measured values – DE DIETRICH AWHP-2 MIT-IN-2 iSystem User Manual
Page 17
4.2
Reading out measured values
The various values measured by the appliance are displayed in the
#MEASURES
menu.
1. To access user level: Press the > key.
2. Select the menu #MEASURES.
4
Turn the rotary button to scroll through the menus or
modify a value.
4
Press the rotary button to access the selected menu
or confirm a value modification.
¼For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 13.
User level - Menu #MEASURES
Parameter
Description
Unit
OUTSIDE TEMP.
Outside temperature
°C
ROOMTEMP.A
(1)
Room temperature of circuit A
°C
ROOMTEMP.B
(1)
Room temperature of circuit B
°C
ROOMTEMP.C
(1)
Room temperature of circuit C
°C
MIT TEMP.
Inside module flow sensor measurement
°C
PRESSURE
Water pressure in the installation
bar (MPa)
WATER TEMP.
(1)
Water temperature in the DHW tank
°C
STOR.TANK.TEMP
(1)
Water temperature in the storage tank
°C
SWIMMING P.T.B
(1)
Water temperature of the swimming pool on circuit B
°C
SWIMMING P.T.C
(1)
Water temperature of the swimming pool on circuit C
°C
OUTLET TEMP.B
(1)
Temperature of the flow water in circuit B
°C
OUTLET TEMP.C
(1)
Temperature of the flow water in circuit C
°C
TEMP.SYSTEM
(1)
Temperature of the system flow water if multi-generator
°C
T.DHW BOTTOM
(1)
Water temperature in the bottom of the DHW tank
°C
TEMP.TANK AUX
(1)
Water temperature in the second DHW tank connected to the AUX circuit °C
DHW A TEMP.
(1)
Water temperature in the second DHW tank connected to circuit A
°C
TEMP.SOL.TANK
(1)
Temperature of the hot water produced by solar power (TS)
°C
SOLAR.COLL.T.
(1)
Solar panel temperature (TC)
°C
SOLA.ENERGY
(1)
Solar energy accumulated in the tank
kWh
FLOWMETER
Plate exchanger flow rate
l/min
NB IMPULS.COMP
Number of heat pump start-ups
RUNTIME HP
Number of hours’ operation of the heat pump compressor
h
IN 0-10V
(1)
Voltage at input 0-10 V
V
SEQUENCE
Control system sequence
CTRL
Software control number (SCU)
(1) The parameter is only displayed for the options, circuits or sensors actually connected.
bar
1
1
2
2
D
STD
J
I
E
0
2
4
6
8
10
12
14
16
18
22
24
20
#
F
AUTO
% $
<
:
!
SUNDAY 11:45
C002219-D-04
AWHP-2 MIT-IN-2 iSystem
4. Operating the appliance
31/03/2014 - 7616372-001-02
16