Datamax-O'Neil Workstation series Programmer’s Guide - Manual (Page 45)

Programmer’s Guide | 1
39 Thermal Printer Programmer’s Guide
PAPERREFLDOWNRIGHT 4 Paper reflective sensor
threshold for the bottom outside
sensor 0-255 128
GAPTRANSLEFT 4 Gap transmissive sensor
threshold for the inside sensor 0-255 128
GAPTRANSRIGHT 4 Gap transmissive sensor
threshold for the outside sensor 0-255 128
MARKREFLUPLEFT 4 Mark reflective sensor threshold
for the top inside sensor 0-255 128
MARKREFLUPRIGHT 4 Mark reflective sensor threshold
for the top outside sensor 0-255 128
MARKREFLDOWNLEFT 4 Mark reflective sensor threshold
for the bottom inside sensor 0-255 128
MARKREFLDOWNRIGHT
4 Mark reflective sensor threshold
for the bottom outside sensor 0-255 128
TRANSCURRENTLEFT 4 Transmissive sensor current for
the inside sensor 0-32 16
TRANSCURRENTRIGHT 4 Transmissive sensor current for
the outside sensor 0-32 16
REFLCURRENTUPLEFT 4 Reflective sensor gain for the
top inside sensor 0-32 16
REFLCURRENTUPRIGHT 4 Reflective sensor gain for the
top outside sensor 0-32 16
REFLCURRENTDOWNLEFT 4 Reflective sensor gain for the
bottom inside sensor 0-32 16
REFLCURRENTDOWNRIGHT
4
Reflective sensor gain for the
bottom outside sensor 0-32 16
FRONTPANELUNITS The units displayed on the
printer front panel IMPERIAL, METRIC IMPERIAL
TIMEONFRONTPANEL Used to display time on the front
panel, or not OFF, ON OFF
MAINTENANCEALARMDIST This notifies the user when
maintenance is required. It is
specified in thousands of
inches. 0 is no alarm. 0 – 1000 (1000”) 0
ERRORRECOVERY Used to reprint labels after an
error, or not REPRINT, NORERPINT REPRINT
PASSWORD Default password for PJL
security 0 – 65535 0
TIMEOUT Used to set the duration of I/O
timeout in seconds. If the printer
waits longer than the timeout
value without receiving any
data, it ends the print job and
begins accepting data from
other I/O ports. 0-300 (s) 1
Variable Description Range Default