Datamax-O'Neil Workstation series Programmer’s Guide - Manual (Page 36)

1 | Programmer’s Guide
Thermal Printer Programmer’s Guide 30
PJL Head Cleaning Procedure/Command
Prior to performing print head cleaning the head clean mode must be entered as follows:
%-12345X@PJL JOB NAME = "JOB_CLEAN_INIT"
@PJL PERFORM HEADCLEANMODE = 1
@PJL EOJ
The media should then be removed and a special cleaning card inserted. Issue the
PERFORM HEADCLEAN command:
%-12345X@PJL JOB NAME = "JOB_CLEAN"
@PJL PERFORM HEADCLEAN
@PJL EOJ
When the cleaning is complete disable the head clean mode:
GPIOREAD Test of GPIO output pins N/A Must be in self test
mode (See below)
PRINTSETTINGS Print the settings report N/A
PRINTINFO Print system info report N/A
PRINTNETWORK Print network report N/A
PRINTSERIAL Print serial report N/A
PRINTGPIO Print Applicator (GPIO)
report N/A
PRINTFONTS Print fonts report N/A
PRINT10 Print internal 10% pattern Quantity to print
PRINT20 Print internal 20% pattern Quantity to print
PRINT50 Print internal 50% pattern Quantity to print
PRINTQL Print internal quality label Quantity to print
SETDATETIME Set data and time String “HHHH-MM-DD
hh:mm:ss”
SETTIMEZONE Set time zone String, i.e. “EST+5” for
Eastern Standard
Time
PRINTSYSREPORT Print abbreviated system
report N/A Workstation Series only
REBOOT Restart printer N/A
PRINTFILE Print user label “filename.pcl” File must be in User
Labels. This typically has
a .pcl extension.
Parameter Description Value Notes