Datamax-O'Neil OC-3 SERIES User Guide - Manual (Page 7)

S
ETTING UP YOUR PRINTER
3
Installing/removing the battery
Note: The battery is already installed in new printers. See
"Removing the battery isolator" on page 2 for information on
enabling the battery in a new printer.
Installing the battery
1. Press the printhead cover release and open the printer, as
shown in Figure 8.
2. Remove any packaging material (if applicable).
3. Position the battery with its contacts facing toward the
battery cavity, as shown in Figure 9.
4. Lower the battery into the battery cavity, fitting the contact
end of the battery into the cavity first, as shown in Figure 10.
5. Slide the battery all the way to the right in the battery cavity
so that the edge of the battery hits the battery stop, as
shown in Figure 11. The printer beeps one time when you
install the battery. Figure 12 shows the fully seated battery.
Figure 7 Figure 5 Figure 6
Figure 10
Figure 8 Figure 9