Datamax-O'Neil OC-3 SERIES User Guide - Manual (Page 16)

OC-3 SERIES OF PRINTERS USER'S GUIDE
12
Using the belt clip
Install the belt clip as follows:
1. Turn the printer so that its back faces you and the belt clip
socket is up, as shown in Figure 26.
2. Place the belt clip over the belt clip socket such that the flat
side of the belt clip swivel matches the flat side of the belt
clip socket (Figure 27).
3. Press the belt clip onto the printer until the swivel is fully
seated into the socket.
4. Rotate the belt clip 180 degrees to lock it into place (Figure
28 and Figure 29).
Reverse the above steps to remove the belt clip.
Figure 26 Figure 27
Belt clip socket Belt clip swivel
Figure 29 Figure 28