Datamax-O'Neil E-Class Mark III 4xxxxxxx Operator’s Manual - Manual (Page 53)

Appendix B – Ethernet Setup 47
Wired Ethernet Settings Page
Acquire Address
Method
Acquire Address Method Controls IP Address discovery, where:
• Use DHCP: Broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway are
not allowed; and, if no server is found, the specified static value will be used.
• Use Static Addresses: Uses the stored static IP, Subnet Mask, and / or Gateway
Address.
Static IP Settings
Printer IP Address
These are the static address the printer will use when Acquire Address Method is set to
“Use Static Addresses” or a valid IP could not be retrieved from a DHCP server.
Printer Subnet Mask
Printer Gateway
Primary DNS Server
Secondary DNS Server
Primary WINS Server
Secondary DNS Server
Ethernet Port
Connection Settings
Duplex Capability Allows the User to specify the line duplex and speed of the wired Ethernet connection.
• Auto-Negotiate (default) • 10 BaseT Full Duplex
• 100 BaseT Full Duplex • 10 BaseT Half Duplex
• 100 BaseT Half Duplex
Printers DNS Name
Printers DNS Name Sets the DNS name of the printer.
NetBIOS Settings
NetBIOS Enable Enables/Disables NetBIOS, where:
• Enables NetBIOS
• Disables NetBIOS
NetBIOS Name Is the name used to reference the printer instead of the IP address. A WINS or DNS
server is required for this capability.
TCP Print Services
TCP Print Port Selects the Port to use for all network communications; the default is 9100.
Inactivity Time (seconds) Sets the time-out (inactivity) threshold in seconds
LPD Print Port
LPD Print Port • Sets the LPD printer port; the default is 515
UDP Management Port
UDP Management Port • Sets the UDP printer port; the default is 9200