ATI Amplifier Technologies ATP8700 - Manual (Page 8)

Remote Control
The remote control for the A/V PROCESSOR is a preprogrammed
universal remote that is the primary control system for the
A/V PROCESSOR. This remote also controls as many as seven
other devices in your system. It contains an extensive library
of IR codes for other devices. Touching any button activates
the remote’s backlighting for five seconds.
1 SETUP Button
Holding down this button for three seconds causes the
remote to enter setup mode. In this mode, you can enter
an entire set of codes for another device to be controlled,
or learn codes directly from another remote.
2 Device Control Selector Buttons
These buttons select the device that the remote will control.
Push the AVC button to control the A/V PROCESSOR.
3 Numerical Keypad Buttons
Use these buttons for control functions requiring you to
enter numbers.
4 Mute Button
This button mutes the ATP's sound in the main room. It
does not affect the second zone output unless Zone 2 is
selected. Mute status isshown on the front panel.
5 VOLUME UP and DOWN Buttons
These buttons control the A/V PROCESSOR’s volume in the
main room. They do not affect the second one output.
6 ALT Button
This button selects an alternate mode.
7 GUIDE Button
Activates the status screen displaying the source, input,
volume setting, and audio output type. Pressing the
GUIDE button while in the Input Assignment Menu will
bring up the Rename Menu (after selecting a source).
This allows the user to rename a source device If desired.
8 Cursor Control Buttons
These buttons navigate the ATP's on-screen menus, as well
as the on-screen menus of DVD players and other devices,
which the remote is programmed to control. The cursor
up and down buttons are also used to adjust certain
parameters of the A/V PROCESSOR.
9 INFO Button
Use this button to get more information about whatever
you’re watching.
Page 8
1 17
18
19
20
21
22
23
25
26
16
2
3
4
5
6
7
8
9
10
11
12
13
14
15
24