ClimaCool UCA Manual - Manual (Page 4)

www.climacoolcorp.com
4
Pre-Installation
Inspection
Upon receipt of equipment, carefully check the shipment
against the bill of lading and inspect each chiller for
any damage incurred during shipment. Thoroughly
check for any visible damage of control panels, electrical
and/or refrigeration components or broken copper lines.
The carrier must make proper notation of any damages or
shortages on all copies of the bill of lading and complete
a common carrier inspection report prior to your fi nal
acceptance of the shipment.
Note: It is the responsibility of the purchaser to fi le all
necessary claims with the carrier. In addition, please
notify the ClimaCool Customer Service Department at
405-745-3185 or [email protected]
of all damage immediately.
Handling of Modules
Carefully remove the module’s packaging. The chiller’s
steel base cutouts provide maneuverability by forklift or
pallet jack into its fi nal position (see Rigging and Lifting
Procedures Figures 1 and 2 on page 8). Verify that all header
grooved couplings, groove by groove 6” nipples and
mounting hardware kits are on site prior to connecting the
modules.
Rigging and Lifting
Each module should be lifted by using a pallet jack or fork
lift. If it is necessary to utilize a crane for rigging or lifting
each module shall be lifted by using lifting straps and
spreader bars using rigging points identifi ed in the Rigging
and Lifting Procedures on page 8.
Warranty
To ensure proper equipment longevity, design performance
and reliability, all ClimaCool chillers must be installed,
operated and maintained in accordance with ClimaCool
IO&M manuals. Water quality is of the utmost importance
for the proper care and maintenance of your modular
chiller system and regular treatment of the water will
increase longevity of your system. Failure to provide
adequate fi ltration or treatment of evaporator water
will void the ClimaCool module’s warranty. A factory
authorized technician is required to perform the startup
of your ClimaCool chiller. Please contact the ClimaCool
Customer Service Department at 405-745-3185 or at
[email protected] to schedule. There
is a minimum of 3 weeks’ notice required to schedule your
factory startup.