CHIEF TS318TU - Manual (Page 19)

Installation Instructions TS318SU/TS318TU/TS325TU
19
Figure 33
Arm Tension Adjustment
1. Use 1/4" hex key (BB) to adjust arm tension at any of the
four arm tension adjustment points. (See Figure 34)
Figure 34
2. Use 9/16" wrench to adjust arm tension directly behind
faceplate. (See Figure 35)
Figure 35
Install Interface Bracket Adhesive Covers
(Optional)
If the interface bracket was required to install display to mount,
adhesive covers may be used to cover the holes on the
interface bracket in order to improve the appearance.
1. Use two long adhesive strips (DD) to cover vertical uprights.
(See Figure 36)
2. Use four short adhesive strips (EE) to cover horizontal
upright supports. (See Figure 36)
NOTE: These strips may be cut as desired in order to fit around
screws.
Figure 36
2 6
4
4
3 5
(swing arms not shown
for display purposes)
arm tension
adjustment points
not adjustable
with hex key
arm tension
adjustment points
(EE) x 4
(DD) x 2
1
2