CEMB USA K10 (D) - Manual (Page 5)

A
B
Spring
DC WD Cone
I 0215 - 5 GB
3.3 - ADAPTER MOUNTING
The wheel balancing machine is supplied complete with
cone adapter for fastening wheels with central bore. Other
optional adapters can be mounted:
a) Remove threaded end piece A after backing off screw B.
b) Mount the new adapter (see enclosed brochures).
Note: CAREFULLY CLEAN THE COUPLING SURFACES
BEFORE PERFORMING ANY OPERATION.
3.4 - WHEEL GUARD ASSEMBLY AND ADJUSTMENT (OPTIONAL)
a) Fasten the components to the base as illustrated in the specific exploded drawing.
b) The position of the wheel guard when closed can be adjusted with relative screw accessible at
the back. Correct position is the one which keeps the tube exactly horizontal with the wheel
guard closed.
c) Check that the microswitch is held down when the guard is closed.
Note: Do not lean on the guard during the wheel balancing cycle.
3.5 - SPACER WD
When balancing very wide wheels (9”), there is not enough space to turn the distance gauge. To
withdraw the wheel from the machine side, fit spacer WD on the adapter body and secure it with
the standard issue nuts. When centring the wheel with the cone on the inside, fit the DC spacer
to obtain spring thrust.
Fig.3a
4 - CONTROLS AND COMPONENTS
4.1 - MANUAL RIM DISTANCE GAUGE
This gauge serves for manual measurement of the distance of the point of application of the counterwei-
ght from the machine.
Fig. 3