CEMB USA K10 (D) - Manual (Page 4)

I 0215 - 4 GB
NOTE: DO NOT HOIST THE MACHINE USING DIFFERENT GRIPS
(See “Correct head disassembly” - paragraph: GENERAL SAFETY REGULATIONS )
1.4 - SPECIFICATION
Weight (excluding adapter) ~ 80Kg.
Single-phase power supply 115 / 230 V 50/60 Hz
Protection class IP 54
Max power consumption 800 W
Balancing speed < 100 min -1
Cycle time for average wheel (14 kg) 6-8 seconds
Max.resolution of measurement 1 gram
Position resolution ± 1.4 °
Average noise < 70dB (A)
Rim-machine distance 0 - 265 mm
Rim width setting range 1.5” ÷ 20” or 40 ÷ 510 mm
Diameter setting range 10” ÷ 26” or 265 ÷ 665 mm
2 - HANDLING AND HOISTING
Fig. 2 Fig. 2a
3 - COMMISSIONING
3.1 - ANCHORING
The machine can operate on any flat non resilient floor.
Make sure that the machine rests solely on the three support points provided (fig.2a).
3.2 - ELECTRICAL CONNECTION
The machine is supplied with a single phase mains cable plus earth (ground).
The supply voltage (and mains frequency) is given on the machine nameplate. It cannot be changed.
Connection to the mains should always be made by expert personnel.
The machine should not be started up without proper earthing.
Connection to the mains should be through a slow acting safety switch rated at 3 A (230V) or 8 A (115V).
See enclosed layout.