Alamo ST15 - Manual (Page 64)

64 ST15 (Archive Book) 01/04
© 2004 Alamo Group Inc.
DOUBLE CHAIN
CHAIN GUARDS
ST15 / ST10
1. Only Double Chain Guards are available.
2. 9 Link sections of Chains are used and are hung by the 5 th link
to form the double Chain Guard. (See illustration below)
3. The Cables are laced through the Bottom Link of the Chain and
then a Cable Clamp is placed at each end of the Cable. (See
illustration below).
4. Front Center Section is in 3 pieces, 1 center (19 Chains) and 2 outer
(16 Chains ea.)
5. The Front Wings are 2 pieces (29 Chains ea.) on each wing, same
LH or RH. There are two Chain Sections that bolt to a lug on the outer
side of each wing.
6. The Rear Center is in 2 pieces (24 Chains ea.)which are both the
same LH or RH Center.
7. The Rear Wings use 3 pieces, The center and inner Wing piece are
the same (19 Chains ea.), the outer for the wings is different (18
Chains)
8. The Chains are held in with a steel rod that is welded to the chain
guard bracket. to change or install chain sections these rods should
be replaced and rewelded.
12345
12345
12345
12345
12345
12345
12345
12345
123456
123456
123456
123456
123456
123456
123456
123456
123456
12
12
12
12345
12345
12345
12345
12345
12345
12345
12345
12
12
12
12
12
12
12
12
12
12
Mower
Deck
Chain Guard
Bracket
Retaining Bolt
9 Link Chain
Section
Retaining Rod
(Welded to
Bracket)
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
123
123
123
123
123
123
123
123
1234567890123456789012345
1234567890123456789012345
1234567890123456789012345
12
12
12
12
12
12
12
12
1
1
1
12
12
12
9 Link Chain Section
is hung by inserting
the 5 th. Link
12
12