Castle TSM-21 Serial 64234 and above (Bosch) Operator Manual User Manual
Page 24

CASTLE, INC
TSM-21 OWNERS MANUAL V2.0
Page 24 of 41
• Turn the Power Switch on (Fig 19).
• Place the work piece to be pocketed on the Work Top. Slide it
under the Clamp Guard and firmly push it against the face plate of
the machine to press the Safety Buttons. (Fig 20).
• Be sure to keep your hands clear of the clamp, then press and
release the Foot Pedal to activate the cutting cycle.
• The pocket will be cut at the point directly under the center of the
Clamp Cylinder.
• When the Pocket Cycle has been completed the Clamp Foot will automatically release the
material.
• A typical machine cycle will take from 1½ to 2 seconds to
complete.
• Reposition the same work piece or a new work piece under the
Clamp Guard, then press and release the Foot Pedal again to
activate the next cutting cycle.
• Be sure to turn off the Power Switch when you are finished.
• If the machine fails to cycle properly, call Castle at (800) 282-
8338
Fig 19
Fig 20