Neff T13D85N0 - Manual (Page 26)

26
Keep warm function
The keep warm function is suitable for melting chocolate or
butter and for warming food and cookware.
Switching on the keep warm function:
1. Use the ( ) symbol to select the hotplate.
2. In the next 5 seconds, touch the L symbol.
– appears in the heat setting display. The keep warm function
is switched on.
Switching off the keep warm function:
Select the hotplate and touch the L symbol.
‹ appears in the
heat setting display.
After approximately 5 seconds, the hotplate is switched off, and
the residual heat indicator appears.
Wipe protection
If you wipe over the control panel while the hob is switched on,
settings may be altered.
To prevent this from happening, your hob has a wipe protection
function. Touch the " symbol. A signal sounds. The control
panel is locked for 30 seconds. You can now wipe over the
control panel without altering any settings.
Note: The main switch is excluded from the wipe protection
function. You can switch off the hob at any time.
Automatic time limit
If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating.
” and ‰ flash alternately in the
hotplate indicator.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Basic settings
Your appliance has various basic settings. You can adapt these
settings to your needs.
Indicator Function
™‚ Automatic childproof lock
‹ Switched off.*
‚ Switched on.
™ƒ Audible signal
‹ Confirmation signal and operation error signal switched off.
‚ Only operation error signal switched on.
ƒ Confirmation signal and operation error signal switched on.*
™† Automatic timer
‹ Switched off.*
‚ - ŠŠ Cooking time, after which the hotplates switch off
™‡ Duration of the timer end signal
‚ 10 seconds.
ƒ n 30 seconds
„ 1 minute.*
™ˆ Activation of the filament circuits
‹ Switched off.*
‚ Switched on.
ƒ Last setting before the hotplate was switched off.
*Basic setting