PA Industries Precision AirFeed User Manual
Page 14
12
MATERIAL ADJUSTMENT
STEP 1. The strip material must be straight and
parallel from the Rear Stock Guides through the
Feed and into the Tool.
STEP 3. Recommended vertical clearance between
the Material and the two Clamps is .010" to .020"
(.3mm to .5mm). Adjust by holding the Clamp
Piston Stem with a Hex Key and turn the Hex Nut.
STEP 2. Adjust the two Roller Stock Guides with
enough lateral clearance for camber and variations
in stock width.
CAUTION! It is very important to have a level Clamp
condition for both the Feed Clamp and the Stock Clamp.