MoTeC VCS - Manual (Page 8)

4 Installation
Installation
Mounting
The camera can be mounted using the roll cage mounting bracket included in
the VCS kit. Ensure the clamp is fitted in the middle of the camera.
It is not recommended to mount the camera using the rear screws as vibration
may cause damage to the camera.
When routing the wiring between the camera and the binder connector, only
lightly pull the cable ties. The wire can be damaged if cable ties are attached
too tightly. The routing should also avoid high heat sources.
Wiring
See Appendices for full connector, loom and wiring details.