MoTeC VCS - Manual (Page 19)

MoTeC Configuration 15
Configure a MoTeC Data Logger
The method described here is based on the ADL3 Dash Logger. Configuration
of other MoTeC Data Loggers will be very similar.
1. Open ADL3 Dash Manager and open a file.
2. On the Connections menu, click Communications.
3. Select an empty CAN slot and click Select.
4. Click VCS Receive.
This will make the following CAN messages, transmitted by the VCS,
available for the ADL3 to log or display:
• Memory
Used
• Diagnostics
• Battery
Voltage
• Internal
Temperature
5. Select another empty CAN slot and click Select.
6. Click VCS Transmit Compound.
This will transmit all channels from the ADL3 to the VCS that are
included in the VCS configuration templates:
• Ground
Speed
• Engine
RPM
• Gear
• Throttle
Position
• Brake Pressure Front
• Steered
Angle
• G
Force Longitude
• G
Force Latitude
• Lap
Distance
If any of these channels is not available in the ADL3, you can disable them in
the VCS configuration template. See Receiving CAN Messages.