MoTeC M84 - Manual (Page 53)

MoTeC ECU Manager Software 51
ECU Status: Connected or NOT Connected (if the ECU is connected the ECU
firmware version is also shown). If the ECU is not connected the reason that it
is not connected is shown where the Diagnostics Errors are normally shown.
The number of diagnostics errors (if the ECU is connected)
Calibration Files
ECU Manager records the ECU calibration and setup data in files that are
stored on the PC hard disk, this ensures that a permanent record of the data
is kept. The files also record comments to allow easy identification of each
file. Any file may be sent to any ECU which will totally re-configure the ECU
according the calibration and setup data contained in the file.
Creating a New Calibration File
To create a new calibration file open an existing file and save it to a new file
by selecting Save As from the File menu.
Sending a Calibration File to the ECU
To send a calibration file to the ECU select Send File to ECU from the File
menu. Note that the ECU must be connected to the PC using a MoTeC UTC or
CAN Cable.
Changing the Comments
To change the file comments select Edit Comments from the File menu.
Versions & Upgrading
MoTeC is continually updating the software and newer versions may be
downloaded from the website at no charge
www.motec.com.au
The software consists of the ECU Manager software that runs on the PC and
the control software (firmware) that runs inside the ECU.
The ECU firmware may be updated at any time by the user which allows the
latest features to be used.
The ECU Manager version may be viewed by selecting About from the Help
menu.
The ECU firmware version is shown on the ECU Manager status line when
the ECU is connected.