Dialight RS5C4K-H StreetSense LED Roadway Sign Light Holophane Retro-Fit User Manual
Page 7
Document No: 9100-127-1480-99 Rev A
Page 7 of 10
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 571-5778 www.dialight.com
2B: Complete fixture Assembly Installation Instructions:
Type SSO (AWG 14-3) cable (normally supplied by user) is recommended for electrical connections to this luminaire.
Flange Mount
1) Remove top cover assembly and place to the side.
2) Drill (3) 3/8” holes where shown in the bottom of the lower unit. Using these holes install housing to mounting to
surface with (4) 5/16” bolts, nuts and lock washers.
3) Make conduit connection to lower unit. Insert the input power cable through the ¾” NPT threaded hole approximately
12”.
4) Follow steps 4 thought 7 above.
Figure 2: View of Complete Dialight Fixture Box Assembly and Mounting Locations
Complete Dialight Fixture Assembly