DE-STA-CO 115RSD - Manual (Page 3)

INTRODUCTION
This service manual pertains to the disassembly and assembly of CAMCO’s RSD servo mechanical drive MODEL
115RSD.
The manual is to be used in conjunction with the General Service Manual which describes the lubrication and
general maintenance of CAMCO Index Drives.
An exploded view illustration of the index drive is included in this manual. The procedures in this manual
reference the item numbers of this illustration.
Also included is a complete Parts List for your convenience in identifying and ordering spare or replacement parts.
Some users of index drives have the facilities and trained personnel to accomplish service repair. You must
determine the extent to which intricate servicing should be done in your facility. When in doubt, CAMCO
recommends that CAMCO trained servicemen make the repairs.
WARNINGS AND CAUTIONS
Statements in this manual preceded by the words WARNING or CAUTION and printed in italics are very
important. We recommend you take special notice of these during service or repair.
WARNING
Means there is the possibility of personal injury to yourself or others.
CAUTION
Means there is the possibility of damage to the CAMCO unit.
SPARE PARTS KIT
CAMCO offers a Spare Parts Kit for all CAMCO index drive models CAMCO builds. These kits include bearings,
shims and cam followers. These are components that will most likely require replacement during repair of your
index drive.
A complete list of components supplied in the Spare Parts Kit can be found in the Bill of Materials in this manual.
An asterisk behind the item number indicates that the part is supplied with the Spare Parts Kit.
BEFORE STARTING
Before starting disassembly of your CAMCO unit, you should read and review the following instructions. These
provide important information on parts and procedures necessary to successfully complete your repair.
NOTE: Numbers in these instructions refer to the Assembly Drawing on page 10 and the Parts List on
pages 11-13.
Comply with all Warnings and Cautions.
Read the “Trouble Shooting Guide” section of your General Service Manual before disassembling CAMCO units.
CAMCO recommends returning defective equipment for inspection and repair whenever possible.
CAMCO uses Permabond ® adhesive to secure all screws and setscrews. If you encounter a fastener that is
difficult to remove, apply heat to the screw and remove while still warm.
2