BatteryMINDer 28252-AA-Series - Manual (Page 7)

Rev. I-100511 Page P/N VDC28252-AA-Series-MNL
BatteryMINDer ® Model 28252-AA-Series
Always follow battery manufacturer’s strict
instructions for proper care, charging and testing of
battery. Always use their FAA Approved “Instructions
for Continued Airworthiness” (ICA). Questions
relating to the subject should be referred directly
to the battery manufacturer to be certain of current
requirements that may have been added to or changed
since publication of their instructions.
NEVER CHARGE A FROZEN BATTERY OR ONE AT A
TEMPERATURE ABOVE 12° F.
PREPARING TO CHARGE
Always remove ground wire first.
Be sure area around battery is well ventilated while battery is
being charged. Force gas vapors away by using a fan.
Clean battery terminals. Be careful to keep corrosion from
contacting eyes.
Study all battery manufacturer’s specific instructions such as
recommended charge rates.
Determine condition of battery, by referring to instructions
herein, before ever attempting to charge or desulfate any /
all batteries.
Make sure unit is as far away from battery as output cables
permit.
Never place unit directly above battery being charged; gases
from battery will corrode and damage unit.
Do not operate unit in a closed-in area or restrict ventilation
in any way.
Do not set battery on top of unit.
DC CONNECTION PRECAUTIONS
Note: Steps to be done in a well-ventilated area.
a. Connect and disconnect DC output clips from battery only
after removing unit power cord from outlet.
b. Attach clips to battery posts and twist or rock back and forth
several times to make good contact. This tends to keep clips
from slipping off terminals and reduces risk of sparking.
a.
b.
c.
d.
e.
f.
g.
h.
i.