BatteryMINDer 28252-AA-Series - Manual (Page 6)

Rev. I-100511 Page P/N VDC28252-AA-Series-MNL
BatteryMINDer ® Model 28252-AA-Series
REQUIRED SAFETY INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TOPERSON, OBSERVE THE FOLLOWING:
This unit is designed for protected use and should never be exposed
to rain.
Do not attempt to use the unit if it has been dropped or damaged.
Never attempt to charge a damaged battery, frozen battery or non-
rechargeable battery.
Do not use the unit in a closed area or poorly-ventilated area.
Never smoke, use an open flame, or create sparks near a battery
or unit during charging operation as this may cause an explosion /
explosive gas.
Do not operate the unit if the cord or plug is damaged.
Do not disassemble. VDC Electronics MUST be contacted for repair,
replacement or analysis. Keep away from infants, children and pets.
Switch off or remove AC power before connecting or disconnecting
to battery.
Refer to the battery Manufacturer’s specific recommended values
to determine if standard unit settings are correct. Contact VDC
Electronics Tech Support before making any changes
Check Battery Manufacturer’s specific precautions - such as removing
or not removing battery from aircraft before charging.
Always remove battery from aircraft before equalizing or desulfating.
Someone should be within range of your voice or close enough to
come to your aid if working near a lead-acid battery.
Wear protective goggles and turn your face away when connecting or
disconnecting a battery.
If battery acid contacts your skin or clothing, wash immediately with
soap and water. If acid enters your eye, immediately flush the eye
with running cold water for at least 10 minutes and seek medical
attention immediately.
To reduce risk of damaging the Battery, avoid dropping any metal
tools onto the battery.
Never rest the Battery being charged on top of your Battery
Charger.
The Battery Charger / power supply should be kept as far away from
the Battery as the output cables permit.
When using the Temperature Sensor at any location other then on a
battery the ring terminal must be insulated.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•