BatteryMINDer 28252-AA-Series - Manual (Page 19)

Rev. I-100511 Page 1 P/N VDC28252-AA-Series-MNL
BatteryMINDer ® Model 28252-AA-Series
To Change the Mode on the BatteryMINDer 28252-AA-Series:
• After the unit is powered on, if you do not press a Mode Button
within 30 seconds, you will need to press the Mode Button
TWICE
• If the unit has not had a Mode changed within 30 seconds, you will
need to press the Mode Button TWICE
In each instance, you only need to press the Mode Button ONCE if
done within 30 seconds after the previous operation
This is a safety feature to help prevent inadvertent operations, similar to
an ATM asking you to confirm a transaction. If a Mode Button has not
been pressed within 30 seconds, the button will be locked in the previous
setting. Once you press the button again, the unit will be unlocked. This
“double-press” feature goes into effect after approximately 30 seconds of
not pressing any buttons.
INSTRUCTIONS:
TEMPERATURE SENSOR Type:
ABS-2825 (At-the-Battery Sensor)
MANDATORY WHEN UNIT IS USED WITH Sealed or Maintenance-
type Aviation batteries, regardless of construction (AGM, Free-
Electrolyte = filler caps)
Do NOT modify by extending or shortening the Sensor cord.
Attaching the temperature sensor to battery:
Connect it to the Positive (+) terminal post (clamp or screw) of the
battery.
ABS-2825
Unit is ON
Press Mode
Button TWICE
Press Mode
Button ONCE
Has Mode been
changed within 30
seconds?
NO
YES