B&K Precision MDL Series - Manual - Manual (Page 16)

16
Menu List
The following menus can be viewed on the VFD display. Use  keys to scroll through the menu
list and press Enter key to enter the selected menu function. Use  keys to scroll through the
VFD screen and press Enter key to enter its submenu. Press Esc to go back to the previous menu
selection. Pressing number keys can directly select a channel.
Setup Menu
Press Setup key to enter the setup menu.
SETUP
MODE
Select working mode
CONST CURRENT Load works in CC mode
CONST VOLTAGE Load works in CV mode
CONST RESISTANCE Load works in CR mode
CONST POWER Load works in CW mode
CONST IMPEDANCE Load works in CZ mode
CC/CV RANGE Switch the range
HIGH RANGE Set high range
LOW RANGE Set low range
I / V / R / W SET Set the working current/voltage/resistance/power value
Vmax/Amax Set up the maximum voltage value/maximum current value
Vmin/Amin Set up the minimum voltage value/minimum current value
∫=2.500A/us Set the rising slew rate (only in CC mode)
∫=2.500A/us Set the falling slew rate (only in CC mode)
TRAN A=0.00A Set up level A value
Ta=0.0005S Set up level A width
TRAN B=0.00A Set up level B value
Tb=0.0005S Set up level B width
T MODE Set up the transient mode
CONTINUOUS Continuous mode
PULSE Pulse mode
TOGGLE Toggle mode
RLC R=7500.0Ω Set up the resistance value
RLC L=0uH Set up the inductance value
RLC C=10uF Set up the capacitance value
EXIT Exit the setup menu