B&K Precision 310 - Manual - Manual (Page 12)

-10-
TEST LEADS
The test leads supplied with the instrument are suitable for
connecting to conductors up to 17mm in diameter or bus bars 17mm
tick. There will be,instances where the item being measured require
larger jaws, and the user is advised to make up his own leads.
There will be occasions when longer leads are required due to the
geometry of the item being tested. Some guidance notes should
assit in the assembly of such leads:
Length of the potential leads should be as short as possible.
Insulated 16/0.2mm, tinned copper wire is recommended. The two
potential leads should have the same length to minimise
inaccuracies due to unbalance.
SUPPLIED POTENTIAL TEST LEADS
+
P test lead is of Red color, shrouded, 4mm safety plug which at
1
one end have a crocodile (alligator) clip for connection to the
resistance to be measured. The other end plugs into the meter
(4mm shrouded) color coded sockets.
-
P test lead is of Blue color, shrouded, 4mm safety plug which at one
2
end have a crocodile (alligator) clip for connection to the resistance
to be measured. The other end plugs into the meter (4mm shrouded)
color coded sockets.
SUPPLIED CURRENT TEST LEADS
+
C test lead is of Green color, shrouded, 4mm safety plug which at
1
one end have a crocodile (alligator) clip for connection to the
resistance to be measured. The other end plugs into the meter
(4mm shrouded) color coded sockets.
-
C test lead is of Black color, shrouded, 4mm safety plug which at
2
one end have a crocodile (alligator) clip for connection to the
resistance to be measured. The other end plugs into the meter
(4mm shrouded) color coded sockets.