Avlex ACT-818 Wideband Single-Channel Digital Receiver - Manual (Page 10)

14 15
GRP cursor starts flashing
Turn clockwise to increase by one group
Turn counterclockwise to decrease by one group
GRP: Group Setting
Operating Procedure:
1. Press the rotary controller  to activate and move the cursor to the GRP
parameter. When the GRP cursor starts to flash, the Group is ready to be set.
2. Rotate the rotary controller clockwise to increase the Group number;
counterclockwise to decrease the Group number.
3. Press the rotary controller once to confirm and save the selected Group number (or
wait for autosave).
GRP CH BAND ANT
MHz ACT RF AF
SQ BA
EQ ADD
Refer to the supplied channel plan for your band to select a specific frequency.
8
NOTE: When the SQ is set at full level (showing 5 bars), the "AutoScan" function
will be disabled and the user may freely select any preset group or channel
manually.
Operating Procedure:
1. Press the rotary controller  to activate and move the cursor to the CH parameter.
When the CH cursor starts to flash, the Channel is ready to be set.
2. Rotate the rotary controller clockwise to increase the Channel number;
counterclockwise to decrease the Channel number.
3. Press the rotary controller once to confirm and save the selected Channel number
(or wait for autosave).
Rotate the controller to AutoScan for an open,
interference-free preset channel
CH: Channel Setting
CH cursor starts flashing
GRP CH BAND ANT
MHz ACT RF AF
SQ BA
EQ ADD
5
Wideband Digital Receivers Wideband Digital Receivers