Autel Autolink AL319 - Manual (Page 30)

29
1) Use the SCROLL button to select Erase Codes from
Diagnostics Menu and press the ENTER/Exit button. (Figure
4.3)
2) A warning message comes up asking for your confirmation.
Figure 4.7
 If you do not want to proceed with erasing codes, use
SCROLL button to select NO to exit. A message of
“Command Cancelled!” show ups. Wait a few seconds or
press any key to return to Diagnostic Menu.
3) Press the ENTER/Exit button to confirm.
 If the codes are cleared successfully, an “Erase Done!”
confirmation message shows on the display.
Figure 4.8
 If the codes are not cleared, then an “Erase Failure. Turn
Key on with Engine off!” message appears.
Erase Codes
Erase trouble codes!
Are you sure?
YES NO
Erase Codes
Erase Done!
Press any key to con.