Autel Autolink AL319 - Manual (Page 13)

12
2) OBD2 cable -- Provides power to tool and communicates
between tool and vehicle.
3) USB cable -- Allows easy update via a PC and an internet
connection.
3.4 Navigation Characters
Characters used to help navigate the scan tool are:
1) “#” -- Identifies the control module number from which data is
retrieved.
2) “Pd” – Identifies a pending DTC when viewing DTCs.
3.5 Keyboard
No solvents such as alcohol are allowed to clean the keypad or display.
Use a mild nonabrasive detergent and a soft cotton cloth. Do not soak
the keypad as the keypad is not waterproof.
3.6 Power
The scan tool is powered via the vehicle Data Link Connector (DLC).
Just follow the steps below to turn on the scan tool:
1) Locate DLC on vehicle.

A plastic DLC cover may be found for some vehicles and you
need to remove it before plugging the OBD2 cable.
2) Plug the tool‟s OBD II cable to the vehicle‟s DLC.
3.7 System Setup
The scan tool allows you to make the following adjustments and
settings:
1) Language: Selects the desired language.
2) Configure Monitors: Sets the monitors you want to test.
3) Unit of measure: Sets the unit of measure to English or Metric.
4) Key Beep Set: Turns on/off key-press beep.
5) Status Beep Set: Turns on/off the I/M Readiness Status beep.